Miyota 1M12 stem removal

I was trying to remove the movement from a Hugo Boss watch with a twist setting stem. The movement is a Miyota 1M12 (helps to be near-sighted sometimes) and while other have asked, I could find no explanation for how to remove the stem.

Turns out, if you look reeeeealy close, you might get lucky and see a tiny arrow pointing to a tiny hole. You must push in this hole (with the stem fully depressed) then pull on the stem and it comes right out.

 

Visual Aides – red arrow points to the stem release hole.

image

Close-up of the hole

image

 

Make sure the crown is pressed in, then use a pin to push down in the hole, and the stem should just be loose. Don’t push too hard, and don’t hold me responsible if you break your watch!

1 thought on “Miyota 1M12 stem removal

Leave a Reply

Your email address will not be published. Required fields are marked *